|
| Author |
Message |
mojo43
Member
|
# Posted: 14 Aug 2012 20:21
Reply
Arrrg, I'm an idiot! I installed a window today and nailed it on the inside of my cabin to the framing and then I installed tongue and groove board around it on the outside. The problem is that the window is recessed into the cabin. I believe I should have installed the window on the outside of the framing. I can't undo it, but I need a way to make sure that water doesn't sit between the window and the siding. Is there a solution?
|
|
customrunner
Member
|
# Posted: 14 Aug 2012 20:22
Reply
can you post a pick
|
|
mojo43
Member
|
# Posted: 14 Aug 2012 20:23
Reply
Here is a pic of what I did. I am talking about the window in the upper part of the cabin.... thanks for any ideas!
|
|
OwenChristensen
Member
|
# Posted: 14 Aug 2012 20:36 - Edited by: OwenChristensen
Reply
I would guess a jam extension to fit will be fine on the sides and top. Maybe a metal flashing on the bottom.
Owen
|
|
Borrego
Member
|
# Posted: 14 Aug 2012 20:45
Reply
If you flashed it correctly with paper before installing, then all you need to do is install jamb extensions as Owen said. Rip a piece of wood on your table saw that extends beyond the T&G 3/4" (attach with finish nail gun), then use 1x4 casing to enclose the whole window as typical. Silicone the top and sides, leave the bottom open to allow moisture to escape.
|
|
johng
Member
|
# Posted: 14 Aug 2012 21:07
Reply
Remove it, cut the nailing fins off and then install it as a retrofit window...trim like the rest.
|
|
mojo43
Member
|
# Posted: 14 Aug 2012 21:49 - Edited by: mojo43
Reply
I did flash it. I will install a flash extension, thanks!
|
|
trollbridge
Member
|
# Posted: 15 Aug 2012 11:57
Reply
Quoting: mojo43 Arrrg, I'm an idiot!
No....just had a brain fart! It happens, don't beat yourself up. Your cabin is looking fantastic...chin up!
|
|
|
mojo43
Member
|
# Posted: 15 Aug 2012 12:00
Reply
Thanks, I was rushing through it so we could get our stuff in the place and start using it. It was a pretty silly thing to do, but I guess that's what happens when you rush!
|
|
trollbridge
Member
|
# Posted: 15 Aug 2012 12:30
Reply
Quoting: mojo43 I was rushing through it so we could get our stuff in the place and start using it.
Been there done that............a few times 
|
|
|
