Small Cabin

Small Cabin Forum
 - Forums - Register/Sign Up - Reply - Search - Statistics -

Small Cabin Forum / Cabin Construction / how to put on T&G pine siding on the ceiling?
Author Message
black_raven
Member
# Posted: 9 Aug 2015 17:13
Reply 


One of my other projects it to put up T&G pine siding - the cheap stuff that is thin and light. Would you use a brad gun w/ 18 gauge staples or use finishing nails w/ a nail gun? I guess both are around 1.25 inches long.

And anyone have experience w/ the hitachi compressor/brad nailer combo?
thanks

black_raven
Member
# Posted: 9 Aug 2015 17:13
Reply 


Oh one other thing...it is going on top of existing drywall ceiling then into the studs.

bldginsp
Member
# Posted: 9 Aug 2015 19:55
Reply 


I wouldn't use staples just cause you'll see the big hole they make, even if puttied. With T+G it's possible to hide the nails by nailing only on the tongue, as with flooring, but I wonder how well it would stay on the ceiling with this method. I'd use finish nails with a nailer, myself.

Don_P
Member
# Posted: 9 Aug 2015 20:10
Reply 


Going through drywall I'd use a 16 guage finish gun with 2" nails. Prefinish the wood and if possible sticker it inside and run AC or dehumidifier for awhile to get the moisture content down to reduce shrinkage gaps. Prefinishing prevents an unfinished edge showing if it does shrink a bit. Crawling out onto the tongue a little bit with the nail also helps keep the nail head hidden if the wood shrinks in service.

Martian
Member
# Posted: 9 Aug 2015 21:41
Reply 


I've done it both ways and found the nails heads pulled through/shot through the thin wood. A staple placed in the groove of the tongue held well. A bead of glue on the drywall before nailing would help if you nail.

toyota_mdt_tech
Member
# Posted: 9 Aug 2015 22:10
Reply 


You can get 16 gauge finish nails in 2" length. Because its overhead, I'd nail it to the ceiling joist. It will barely leave a mark. Brads may be too small and not long enough. Drive the nails in slightly sideways, and next one sideways in the opposite direction, no way will it come down

black_raven
Member
# Posted: 10 Aug 2015 14:19
Reply 


Thanks All
as I was about to buy a new compressor/brad/nailer combo..the guy at the store said he thinks this will split the cheap thin siding everytime the gun fires. So that got me thinking adhesive only..but I doubt that would hold.

So I think I might go with the brad gun w/ 18 g staples as
Martian recommends. I guess i'll find out either way. Also I can use the nailer to put up siding outside eventually.

thanks

Don_P
Member
# Posted: 10 Aug 2015 22:57 - Edited by: Don_P
Reply 


I'm not particular as to guage or staple vs nail but I would try to get an inch of penetration into the ceiling joists. Remember you are driving at about a 45 degree angle unless you are face nailing. Hanging that amount of weight on just the drywall screws is a recipe for a ceiling collapse. You should be able to adjust the drive depth on the gun to avoid the punch through described above. If not, prior to depth adjustment we did it by lowering the air pressure to the gun, not as good a method since the density of the wood varies so much.

toofewweekends
Member
# Posted: 11 Aug 2015 01:31
Reply 


I used 1.5" into ceiling & wall studs/rafters w/o dry wall. Has held nicely for 5+ years in a cabin that goes below freezing for weeks at a time. Mostly nailed the tongue with a few face nailed where there was limited space. I did mine with hammer... so an occasional hit finger was the only damage.

cbright
Member
# Posted: 11 Aug 2015 13:57 - Edited by: cbright
Reply 


I used 16 gauge 2" nails into 2"x6"s ... worked like a charm and super easy to put up. If going through drywall, just use the longest you nail gun will take. P.S. I pre-finished all the wood before putting up (as suggested above)
celing2.jpg
celing2.jpg
celing1.jpg
celing1.jpg


black_raven
Member
# Posted: 11 Aug 2015 21:49
Reply 


Thanks Don_P...i didn't think of that. I'm ok with face nailing as it is a pretty rustic off-grid cabin.

Your reply
Bold Style  Italic Style  Underlined Style  Thumbnail Image Link  Large Image Link  URL Link           :) ;) :-( :confused: More smilies...

» Username  » Password 
Only registered users can post here. Please enter your login/password details before posting a message, or register here first.